crystallinity In A Sentence

Learn how to use crystallinity in a sentence and make better sentences with `crystallinity` by reading crystallinity sentence examples.

• Comonomers such as CHDM or isophthalic acid lower the melting temperature and reduce the degree of crystallinity of PET ( especially important when the material is used for bottle manufacturing ).
• Each of these steps is crucial for the crystallinity, uniformity and stoichiometry of the resulting film.
• You can almost see the crystallinity swirling around in the air like snow in a Jack Frost cartoon.
• Hydrothermal synthesis produces with good crystallinity.
• The undrawn MPPAN yarn has lower crystallinity and crystal size, fairly high mechanical strength...
• Biodegradation of PDLA is slower than for PLA due to the higher crystallinity of PDLA.
• The distribution of molecular weights and degree of crystallinity influences the width of melting temperature range.
• The experiment results of crystallinity in some organic solvents showed that there was a strong tendency to spontaneous nucleation in the solution of OGO.
• Effect of different fillers on mechanical properties and crystallinity of trans-1,4-polyisoprene (TPI) was investigated .
• The addition of surfactants to solutions often results in a phase change in the solution leading to a liquid crystallinity.
• The crystallizability and crystallinity of PBT were increased with the increase of mixing time.
• If the illite crystallinity values fall in the 0.30-0.42 ?? range, it corresponds with a metamorphic low anchizone or prehnite-pumpellyite facies.
• A research has been made on the effects of the grain size, crystallinity and quantity of crystal quartz in siliceous raw material on the burnability of cement raw meal.
• The effect of branching is to decrease the percentage crystallinity, broaden the melting range, and reduce the average melting temperature.
• Microcrystalline starch is a kind of aggregate of microcrystal strand, crystalline lamellae or other crystal form with high crystallinity .
• Use of stereospecific catalysts can lead to heterotactic PLA which has been found to show crystallinity.
• IR analysis shows that the crystallinity index of the bleached pulp is lower than that of unbleached pulp.
• Generally it is very difficult to tackle the problems aroused from differences in crystallinity of clay minerals and preferred orientation in quantitative X-ray diffraction analysis of clay minerals.
• Acetanilide and hexane diacid, potassium hydrogen phthalate could improve PVC crystallinity.
• These factors influence the polymers crystallinity, melt and glass transition temperatures and molecular weight.
• The high isotacticity and crystallinity of the insoluble fraction make the material remain superior rigidity.
• After hydrothermal treatment the phase changed to boehmite. The obtained product also has good crystallinity.
• The crystallite size, degree of crystallinity and thermal properties of the at various temperatures have been studied by using WAXD and DSC.
• Illite crystallinity can be used to trace the low grade metamorphic transition from zeolite facies to greenschist facies ( diagenetic zone to epizone ).
• For example, the size, composition, crystallinity, or alignment of the fibers will dictate the properties of the composite.
• XRD structural analysis shows that peak intensity of the annealed sample is greater than that of the unannealed one which demonstrated an increase of crystallinity.
• The undrawn MPPAN yarn has lower crystallinity and crystal size high mechanical strength higher water shrinkage.
• If the illite crystallinity values fall in the 0.25-0.30 ?? range, it corresponds with a metamorphic high anchizone or prehnite-pumpellyite facies.
• The synthetic products have high crystallinity, purity and cation exchange capability.
• However, attempts to estimate percentage crystallinity in a sample using n.m.r. have not been particularly successful.
• The composites cooled inside the hot-press machine has lower void content and higher crystallinity and tensile strength than that in the nature-cooling condit...
• Illite crystallinity is useful when trying to determine what type of metamorphic conditions a rock was subjected to during its formation.
• The technique is a time-honored but a somewhat out-of-favor technique for the determination of degree of crystallinity of polymer samples.
• The more rapid the cooling, the finer the grain size and the poorer the crystallinity.
• The crystalline structure of micronized starch was partially destroyed, part of the maltese cross was lost, the intensity of birefringence was weakened, and crystallinity was reduced significantly.
• The results showed that the crystallinity of cotton fiber increased after being slightly oxidised , but decreased after being severely oxidised .
• Vinylidene chloride polymer resin composition and crystallinity influence on the copolymer characteristics were discussed, improving methods of latex performance were introduced.
• The PHB homopolymer is a stiff and rather brittle polymer of high crystallinity, whose mechanical properties are not unlike those of polystyrene, though it is less brittle.
• The crystallinity of ceramic materials ranges from highly oriented to semi-crystalline, and often completely amorphous ( e . g ., glasses ).
• The crystallinity of wet-spinning PAN precursor fibers gradually reduces during preoxidation process, while it gradually increases during carbonization process.
• If subjected to cold drawing afterwards, the fibers align further, increasing their crystallinity, and the material acquires additional tensile strength.
• But if the heat treatment time was too long, the crystallinity and the storage modulus were decreased because of the disentanglement of some weak link.
• The focus of an illite crystallinity XRD plot is the main peak.
• If the illite crystallinity values fall in the 0-0.25 ?? range, it corresponds with a metamorphic epizone or greenschist facies.
• The formal Nickel ( 1995 ) definition explicitly mentioned crystallinity as a key to defining a substance as a mineral.
• The latter can be monitored through the line shape of NMR signals and used to estimate the degree of crystallinity.
• The main problem of TiO 2 is its bandgap which is 3 or 3.2 eV according to its crystallinity ( anatase or rutile ).