compressive stress In A Sentence

Learn how to use compressive stress in a sentence and make better sentences with `compressive stress` by reading compressive stress sentence examples.

• Experiment shows, polymer polybasic alcohol can effectively enhance the compressive stress of polyamine soft foam plastic.
• The method of cold work hardening is applied to increase the permanence limit and to decrease the compressive stress of groove and little round angle of turn angle on mechanic components.
• Metal whiskers form in the presence of compressive stress.
• Buoyant mantle diapir can locally enhance the compressive stress which may be sufficient for the development of thrust faults.
• Shear zones accommodate compressive stress by movement on foliation planes.
• The larger ion squeezing into surface introduces compressive stress in the glass's surface.
• Uniaxial compressive stress, acting perpendicular to the skin surface.
• Wear resistance behavior of induction hardened parts depends on hardening depth and the magnitude and distribution of residual compressive stress in the surface layer.
• The numerical results show that the elephant foot bulging is in fact buckling failure which is caused by the overcritical compressive stress rather than intensity failure.
• This factor, combined with the small spot size, requires many shots to achieve a significant surface compressive stress and depths of 1 mm.
• The compressive stress depth achieved with the most common processing parameters ranges from deep.
• Tensile stress and compressive stress have different effects on the magnetic domain structure.
• Thus, under the same bolt tension, reduce narrow smooth surface after the compressive stress will increase.
• This distinction requires that the rock was under extreme compressive stress, not tension as the slow weathering theory implies.
• In sliding friction, increased compressive stress is proportionally equal to a rise in potential energy and temperature within the contact zone.
• Owing to the loss of their adjacent material constraint, the residual stress on the cutting edge of the small test block reduces, even changing from compressive stress to tensile stress.
• In contrast, ideal fluids can only be subjected to normal, compressive stress which is called pressure.
• The dynamic impact stress vs strain characteristic of St, N. ceramics is tested by use of a Hopkinson pressure bar, and is compared with static compressive stress vs strain characteristic.
• The mechanics behavior of membrane material under residual stress and compressive stress has been studied.
• On the contrary, if temperature gradient is relatively low, combustor only undergo low compressive stress at high temperature. The combustor of engine has a longer life length.
• The design strength for a concrete strut in a region with transverse compressive stress or no transverse stress may be calculated from Expression (6.55) (see Figure 6.23).
• Stress-strain curves show that the ranges of compressive stress and the elastic modulus of mortar decrease with the increasing strain after mixing waste rubber powder.
• Plastic deformation induces a residual compressive stress in a peened surface, along with tensile stress in the interior.
• Destruction mechanism of rock included crack under compressive stress condition had been discussed.
• The first layers applied produce a tensile surface stress due to surface melting, although a compressive stress is developed below the melt layer.
• This design is the most resistant to compressive stress and without it no material could resist water pressure at submarine depths.
• The study result shows that the Hall coefficient(absolute value)of n-Si samples will decrease with the increase of compressive stress.
• 4 Some writers have indeed contended that the stress in magnetized iron is not compressive, but tensile, even when, as in the case of a ring-magnet, there are no free ends.
• This critical stress can be tensile or compressive.
• It is more amorphous, meaning it is weaker under compressive forces, but can hold the rocks together and limit cracking under tensile stress.
• Can a bending load makes both compressive and tensile stress in a member?.